Quote:
Originally Posted by Feroz1325
<snip>
However we are trying to find some CAD drawings or measurements or even pictures!
Does anyone have CAD drawings of these gearboxes?
<snip>
|
See attached CIM-U-LATOR photos.
I really don't know what Banebots is thinking. It has been out there a year and still know photos on their website. I am confident they'd sell many more if folks could see what they look like.
There is a lot to like about these little guys.
I purchased both versions from Banebots this past fall. I also purchased the AndyMark CIM-sim.
There is a lot to like about the CIM-sim too.
Things not to like too (e.g. I don't like AndyMark's use of clinch studs -- one came out in the sample I purchased. I don't like the low 2.7:1 ratio on the CIM-U-LATOR I don't like that both block the vent holes on the front of the motor - but lots of folks do this, including my own dang self often in the past).
I have just uploaded a bunch of photos of both these gearboxes to Dropbox --
here is a link to the gallery
Good luck.
Joe J.