|
Re: cRIO updating to v43 Image issue
Quote:
Originally Posted by KenBudnik
Not sure what to try next. Frustrating.
|
That sounds like when comm gets dropped at the point of the changing of the cRIO IP address. - Disable ALL unused PC network connections, leaving only the Ethernet port active.
- Set the Ethernet port to your 10.xx.yy.5
- Connect the PC Ethernet port to the robot bridge (or any network switch really)
- Connect the cRIO to the network switch as well
- Attempt to Image the cRIO
P.S. If you have network connection issues, some general recommendations: - Turn off PC firewall
- Turn off anti-virus
- Turn off all network ports, except for the one you're using for the cRIO
- Check IP addresses all along the line
- Look to see what all the cRIO status lights are doing, particularly Status, Power, & FPGA
- Look at the Ethernet connection status lights all along the line: PC port, switch ports, cRIO port
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 15-01-2012 at 08:50.
|