[Mark McLeod]

Originally Posted by KenBudnik

Not sure what to try next. Frustrating.

That sounds like when comm gets dropped at the point of the changing of the cRIO IP address.

• Disable ALL unused PC network connections, leaving only the Ethernet port active.
• Set the Ethernet port to your 10.xx.yy.5
• Connect the PC Ethernet port to the robot bridge (or any network switch really)
• Connect the cRIO to the network switch as well
• Attempt to Image the cRIO

P.S. If you have network connection issues, some general recommendations:

• Turn off PC firewall
• Turn off anti-virus
• Turn off all network ports, except for the one you're using for the cRIO
• Check IP addresses all along the line
• Look to see what all the cRIO status lights are doing, particularly Status, Power, & FPGA
• Look at the Ethernet connection status lights all along the line: PC port, switch ports, cRIO port