Thread: Andy Mark Plaction Wheel Dimension Discrepancy!
View Single Post
  #1   Spotlight this post!  
Unread 15-01-2012, 20:34
coreyjon's Avatar
coreyjon coreyjon is offline
Flight Engineer
FRC #0250 (Team 250 Dynamos)
Team Role: Mentor
  
Join Date: Feb 2003
Rookie Year: 2001
Location: Upstate, Ny
Posts: 184
coreyjon is just really nicecoreyjon is just really nicecoreyjon is just really nicecoreyjon is just really nicecoreyjon is just really nice
Send a message via AIM to coreyjon
Andy Mark Plaction Wheel Dimension Discrepancy!
Hello All!

Looking for some clarification. On the Andy Mark webpage the width of the 8" Plaction wheel is 1.54" Inches. I've downloaded the Inventor Model and it measures around 1.625". Of course I found this out after building my model and going crazy trying to figure out why a spacer was off! (drove me nuts)!! It was completely my fault for assuming the width of the wheel model would be the same as the listed width on the website.

Does anyone have an actual width (a measurement from an actual 8" wheel) or could Andy Mark (If he reads this) post clarification as to which is the correct dimension!

-Going crazy with constraints in New York!
__________________
"Jack of all trades, master of none, though offtimes better than master of one".
Reply With Quote