Thread: Ball Pitcher Hood Design
View Single Post
  #8   Spotlight this post!  
Unread 16-01-2012, 20:25
JellyMan JellyMan is offline
Mentor, Team 3414
AKA: Jeff
FRC #3414 (Falcon Robotics)
Team Role: Mentor
  
Join Date: Jan 2010
Rookie Year: 2010
Location: Farmington, MI
Posts: 17
JellyMan has a spectacular aura aboutJellyMan has a spectacular aura about
Re: Ball Pitcher Hood Design
Update:
We modified our prototype ball pitcher today by replacing the flat top plate with a curved hood. The hood starts vertical behind the pitching wheel, and extends through a 45 degree arc, so the ball leaves the wheel at a 45 degree angle.

I am happy to report that the ball velocity is at least as fast as with the flat plate the other day. It may even be a bit faster ... it was hard to tell because the elevation angle is now a little higher than before, and the ball hits the ceiling under maximum power (a good sign). We are working in a portable classroom with a low ceiling.

Stay tuned!
GO FALCON ROBOTICS / TEAM 3414!