Thread: Ball Pitcher Hood Design
View Single Post
  #12   Spotlight this post!  
Unread 16-01-2012, 21:35
roborat roborat is offline
Registered User
#1249
  
Join Date: Mar 2005
Location: Mingo County West Virginia
Posts: 143
roborat is a splendid one to beholdroborat is a splendid one to beholdroborat is a splendid one to beholdroborat is a splendid one to beholdroborat is a splendid one to beholdroborat is a splendid one to beholdroborat is a splendid one to beholdroborat is a splendid one to behold
Re: Ball Pitcher Hood Design
Quote:
Originally Posted by squirrel View Post
Here's ours, which sounds like it's working about the same as theirs.

http://www.youtube.com/watch?v=jeLe2WWemWA

We never got around to trimming the top of the shooter, so the students are holding it at an angle. It's not quite 45 degrees. There is a Lexan flap behind the shooter, that is being held down over the top of the ball before inserting the ball into the shooter.

http://www.youtube.com/watch?v=jeLe2WWemWA
What motor are you using to spin the wheel, we used a single wheel when we had the shooter a few years ago and used a CIM. We are not for sure if we want to use two wheel or one, I like the one wheel because of the amount of space required