Thread: Ball Pitcher Hood Design
View Single Post
  #13   Spotlight this post!  
Unread 17-01-2012, 16:37
gpetilli gpetilli is offline
Registered User
FRC #1559
  
Join Date: Jan 2009
Location: Victor, NY
Posts: 285
gpetilli is a name known to allgpetilli is a name known to allgpetilli is a name known to allgpetilli is a name known to allgpetilli is a name known to allgpetilli is a name known to all
Re: Ball Pitcher Hood Design
Quote:
Originally Posted by squirrel View Post
Here's ours, which sounds like it's working about the same as theirs.

http://www.youtube.com/watch?v=jeLe2WWemWA

We never got around to trimming the top of the shooter, so the students are holding it at an angle. It's not quite 45 degrees. There is a Lexan flap behind the shooter, that is being held down over the top of the ball before inserting the ball into the shooter.

http://www.youtube.com/watch?v=jeLe2WWemWA
It seems that the amount you compress the ball is a critical parameter. Too little and you get slip, too much and you waste energy. We are looking at about 1.5inch compression of the wheel on the ball. Can you share what you are using and how you calibrated it?