Thread: Gyro/Acclerometer Wiring
View Single Post
  #7   Spotlight this post!  
Unread 18-01-2012, 22:31
CRLS97 CRLS97 is offline
Registered User
FRC #0097
  
Join Date: Jan 2011
Location: Cambridge
Posts: 28
CRLS97 is an unknown quantity at this point
Re: Gyro/Acclerometer Wiring
Hey guys I'm a programmer from team 97, Bionic Beef.

I have the wiring set up for the gyro and it gives feedback, however as I rotate it, I know it's not accurate. Rotating it 90 degrees only shows a ~45 degree change in what it reads and I tried adjusting the Volts/degree settings but no luck with that.

Also, with the accelerometer example provided with LabVIEW, after wiring it correctly (and I tried both interfaces), I get no feedback at all.

Apologies if this is the wrong thread to post this in :x