Another cause of this error is caused by the setup utility - Greg (of NI) confirmed that there was a problem with the camera setup utility that causes errors such as this. Set up the camera manually. Reset the camera by holding the button on the back and follow these steps:
1) Connect to the camera at
http://192.168.0.90 (your ip address will need to be on the same domain)
2) The camera will ask you to create a root password - "admin" will work.
3) Log into the camera with root:admin
4) Using the setup page, add the user FRC, password FRC as admin.
5) If you're planning on using the Smart Dashboard, enable anonymous viewing
6) Change the IP address of the camera to 10.te.am.11
Once you save that last setting, you will not be able to connect to the camera. It should be set up at this point.