[blairmi2]

All,

This is the first year our team is doing CAN and we're using only black jags. We successfully connected to a single jag and read the configuration (fan speed, temp, voltage, etc). We went ahead and tried updating to firmware 101 and it failed. Tried another 10 times or so to recover with no luck. Tried again on a second jag and had the same failure. Both now seem to apear to be stuck on the bootloader and have no flashing status light. Any help reflashing or linking to a previous firmware version to try would be greatly appreciated.

setup:

Using usb to serial -> serial to CAN adapter (home made)-> black jag on left port -> bus terminal on black jag right port.

successfully read black jag config. using latest BDC_COMM 101