|
Re: electrical connections for pneumatic
Slot 3 or Slot 7 will work.
The module ordering is as follows:
1: This MUST be an analog module on both cRio's.
2: This MUST be a digital module on both cRio's.
3: Optional solenoid module on both cRio's
4. Optional wildcard module on 4-slot, empty on 8-slot
5: Optional analog on 8-slot
6: Optional digital on 8-slot
7: Optional solenoid on 8-slot
8: Always empty
In LabVIEW, you can address the module as "solenoid module 1" for slot 3 or "solenoid module 2" for slot 7. I don't know what the example uses, check that.
Also, you must have a driver station connected and be enabled for the outputs to turn on. This is probably the cause, if it's not code addressing.
__________________
Kettering University - Computer Engineering
Kettering Motorsports
Williams International - Commercial Engines - Controls and Accessories
FRC 33 - The Killer Bees - 2009-2012 Student, 2013-2014 Advisor
VEX IQ 3333 - The Bumble Bees - 2014+ Mentor
"Sometimes, the elegant implementation is a function. Not a method. Not a class. Not a framework. Just a function." ~ John Carmack
|