Thread: CIM-U-LATOR CAD file
View Single Post
  #5   Spotlight this post!  
Unread 22-01-2012, 14:53
TerryS's Avatar
TerryS TerryS is offline
Registered User
FRC #2445 (RoboKap)
Team Role: Mentor
  
Join Date: Jan 2011
Rookie Year: 2009
Location: Kapolei, HI USA
Posts: 83
TerryS is an unknown quantity at this point
Re: CIM-U-LATOR CAD file
Imported fine! Just a couple of face repairs needed on one of the parts, but SW took care of this automatically. Thanks for sharing!

One minor question: the Banebots webpage info says that the #10-32 mounting hole pattern on the top of the two plates should form a .75x.75 square when assembled. The dimensions in your model are slightly different. Are your dimensions based off measurements?