|
Re: Banebots RS-775 Case Short
Quote:
Originally Posted by Al Skierkiewicz
Again,
I have to ask what resistance was measured in both cases, Karthik and Brando?
|
I haven't tested any this year, so my recollection is based on last years, but it ranged from dead shorts to 1M ohm resistance on failed motors.
Typically if we got into the 10k 0hm range, we started to have massive issues. If we were above 1M ohm, we would typically run a match with that motor. If it was below that threshold, we would continue zapping to get it higher.
__________________
MORT (Team 11) '01-'05 :
-2005 New Jersey Regional Chairman's Award Winners
-2013 MORT Hall of Fame Inductee
NUTRONs (Team 125) '05-???
2007 Boston Regional Winners
2008 & 2009 Boston Regional Driving Tomorrow's Technology Award
2010 Boston Regional Creativity Award
2011 Bayou Regional Finalists, Innovation in Control Award, Boston Regional Finalists, Industrial Design Award
2012 New York City Regional Winners, Boston Regional Finalists, IRI Mentor of the Year
2013 Orlando Regional Finalists, Industrial Design Award, Boston Regional Winners, Pine Tree Regional Finalists
2014 Rhode Island District Winners, Excellence in Engineering Award, Northeastern University District Winners, Industrial Design Award, Pine Tree District Chairman's Award, Pine Tree District Winners
2015 South Florida Regional Chairman's Award, NU District Winners, NEDCMP Industrial Design Award, Hopper Division Finalists, Hopper/Newton Gracious Professionalism Award
|