Thread: bumper design
View Single Post
  #4   Spotlight this post!  
Unread 26-01-2012, 18:19
eedoga's Avatar
eedoga eedoga is offline
Registered User
FRC #2980
  
Join Date: Jan 2011
Location: Oak Harbot
Posts: 225
eedoga has much to be proud ofeedoga has much to be proud ofeedoga has much to be proud ofeedoga has much to be proud ofeedoga has much to be proud ofeedoga has much to be proud ofeedoga has much to be proud ofeedoga has much to be proud of
Re: bumper design
Our interpretation is that there should be no less than 8 inches of bumper on each end of each side. so if you have your frame at 27 * 37 and the hole is on your 27 side, then the hole will be 11 inches wide. The ball is 8 inches wide which gives you a few inches on each side. If you have a wide frame then your hole can be 21 inches wide...

Hope this helps.