|
Re: Probes (and some other aspects) not working
All right, the project is attached. Here is the (in)consistent repro:
1) Download the code to the robot
2) Without enabling the robot (you can enable it, this just saves you a step), just go to Robot Main --> Periodic Tasks --> Mobility System.vi
3) Put some probes around. Nearly all of them say "Not Executed."
One curious example is the Gyro1, which is updating the front panel, but shows "Not Excuted" on the wire going into it on the Block Diagram.
Any red flags in our code that would explain this strange failure?
Last edited by JohnGilb : 26-01-2012 at 21:34.
|