Hi, all.
We're trying to reimage our cRIO from the 2011 to 2012 image, and although everything is set up correctly (IP addresses are right, subnet mask is fine, the crossover cable is plugged into the right port, and the robot is even on) when we try to run the 2012 cRIO Imaging Tool we get an error that says "No CompactRIO devices were found. Verify the network connection." If we open up the 2011 imaging tool the cRIO is listed as being there, but we can't update the cRIO with it (I've heard it's because it's such a different image that you
need to use the 2012 imaging tool). Our mentors and I have been tearing our hair out for the past two days over this, so we really need some help.
Has anyone else had this problem/resolved it?