Quote:
Originally Posted by Alan Anderson
Which style of connector are you using? Typically, the black wire goes to "ground" and the red wire goes to the pin you're using to control the solenoid. For a 24 volt solenoid, you will be using the Solenoid Breakout board on the NI 9472 digital sourcing module in slot 3 of the cRIO. Follow the Robot Power Distribution Diagram (24V Solenoid). |
I am making my own wires.There are no wires coming out from the solenoid valve so I need to decide which pin should be wired to the red wire that goes to the breakout and which should be wired to the black.
Except of that , I know that it should be wired to the solenoid breakout.