Thread: Help please (OHIO)
View Single Post
  #11   Spotlight this post!  
Unread 31-01-2012, 15:45
j.cole j.cole is offline
Registered User
FRC #0379
  
Join Date: Jan 2010
Location: Girard
Posts: 159
j.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud ofj.cole has much to be proud of
Re: Help please (OHIO)
What I'd start with is making sure that the cRIO has been imaged properly.
1. Connect the robot to the development PC through port 1 on the cRIO.
2. Make sure to turn all other NIC's on the development PC off. (wireless cards, other ethernet ports)
3. Turn your robot on.
4. Open the Driver Station
5. Click the diagnostic tab on the Driver Station window.
6. Wait for the cRIO to connect.
7. The DS version should be 11.30.11.00
8. The cRIO version should be FRC_2012_xx.zip
9. If thats all good post back.
__________________

It's not normally a good idea to give a programmer a drill but rules are made to be broken.
Reply With Quote