[Team3763 Adam]

I have run into yet another problem.

In LabVIEW, I cannot get our other 2 motors to respond to the programming. I've tried with 4-motor and 2-motor drives, and nothing works. We've checked all the hardware and wirings, with nothing working. If anyone can help, it would be great.

I made sure I had everything edited properly in Teleop, Begin, and Finish vi's.
Motors 3 and 4 were wired into PWMs 3 and 4, with neither working. However, 1 and 2 DO work, but because they were pre-programmed, I have no clue what the problem could be.

A simple schematic would be great. A screenshot, anything really.

In need of desperate help.