[Cecil]

Which firmware should we be using at this point? We had ver. 2.5 running on the 1st gen board, and it seemed to work. That was until we tried updating the firmware - sent it into the bootloader. After that, I reflashed it with the 2.21 firmware, hooked it up to a second Jag, and that one also went to bootloader saying it had a timeout. Eventually, I just gave up and flashed them with BDC-Comm.

Trying to load the code, on the reboot, it seemed to hang again as the system was up, but the code would not load until a physical hard reset was done. I remember seeing this issue last year, but thought it was taken care of with an .out file update.. Is there any update to that too? I can verify if that is what is happening tomorrow for sure (I didn't have a serial cable hooked up to see where it was hanging)