[rivasm]

Today, we setup our axis camera with the setup axis camera tool. We were exuberant with glee when we turned on our driver station and could receive images from the camera. Then, we turned off our robot, and back on, and we had no more signal from the camera. So, our first instinct was to re-setup using the setup axis camera tool. We got camera input once again, until we restarted the robot again. We used the yellow crossover to achieve the setup, and changed the IP of the computer we were using the setup tool on to 192.168.0.57. The IP of the camera is 10.25.56.11 after setting it up.