Quote:
Originally Posted by akoscielski3
Where was it in the rules that it says that both ends of the bumpers must be supported by the frame perimeter. I just need to know where this rule is, not really saying it doesnt exist.
Thanks  |
Rule <R33>, was added in in a Team Update (I forget which one)
Quote:
|
Bumpers must be supported by the structure/frame of the Robot (i.e. each end of the Bumper must be rigidly attached to the Frame Perimeter, the gap between the backing material and the frame must not be greater than ¼ in. and no section of Bumper greater than 8 in. may be unsupported). See Figure 4‑7.
|
Emphasis mine