Thread: Remember to use washers and not over tighten
View Single Post
  #12   Spotlight this post!  
Unread 09-02-2012, 16:04
Kevin Sevcik's Avatar
Kevin Sevcik Kevin Sevcik is offline
(Insert witty comment here)
FRC #0057 (The Leopards)
Team Role: Mentor
  
Join Date: Jun 2001
Rookie Year: 1998
Location: Houston, Texas
Posts: 3,647
Kevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond repute
Send a message via AIM to Kevin Sevcik Send a message via Yahoo to Kevin Sevcik
Re: Remember to use washers and not over tighten
To the Riv-Nut Proponents:

We've used these in some locations in the past, only to have them strip their holes and start spinning on us. This was (I believe) in some 1"x1"x1/16" aluminum tube. I'd love to use them more/again but I was somewhat put off by them causing us to miss a match when we couldn't remove a bumper. Do you have any suggestions as to what we did wrong?
__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.

Lone Star Regional Troubleshooter