Thread: Soldering Wires to Motors
View Single Post
  #1   Spotlight this post!  
Unread 10-02-2012, 15:34
ChuckDickerson's Avatar
ChuckDickerson ChuckDickerson is offline
Mentor / Bayou & CMP Division LRI
FRC #0456 (Siege Robotics)
Team Role: Mentor
  
Join Date: May 2004
Rookie Year: 2004
Location: Vicksburg, MS
Posts: 877
ChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond reputeChuckDickerson has a reputation beyond repute
Soldering Wires to Motors
Does anyone have any good advise on the best way to solder wires to the FP, Banebots (775, 550,...), etc. motor terminals. I am looking for best electrical practices. They can be a little difficult to solder 12GA or 14GA wire to. We have used 3/16" female spade connectors and soldered those onto the wire and terminals in the past but I am looking for better ideas. Anyone have any?
Last edited by ChuckDickerson : 10-02-2012 at 16:04.