Thread: RSL wire size
View Single Post
  #6   Spotlight this post!  
Unread 13-02-2012, 09:54
RufflesRidge RufflesRidge is offline
Registered User
no team
  
Join Date: Jan 2012
Location: USA
Posts: 989
RufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant future
Re: RSL wire size
Quote:
Originally Posted by Gary Dillard View Post
The RSL runs off of pwm size terminals as well, but I'm not sure what voltage it uses (I guess I could measure it).
The RSL runs off 12V. If this year's [R43-C] and [R44] apply to it then I can count on one hand the number of legal robots I have seen since the RSL was introduced. Most teams use either the KOP 2-wire jumper or a PWM cable, very few use the "correct" Molex connector.