|
Re: Rookie FRC Team 4209 TigerBytes Week 5 Update
I'd be concerned about:
[R33]
Bumpers must be supported by the structure/frame of the Robot (i.e. each end of the Bumper must be rigidly attached to the Frame Perimeter, the gap between the backing material and the frame must not be greater than ¼ in. and no section of Bumper greater than 8 in. may be unsupported). See Figure 4‑7.
It doesn't look like you could adequately secure and support the bumpers for 8in onto the intake side of your frame. Just a thought to double-check.
Otherwise it looks good!
__________________
Theory is a nice place, I'd like to go there one day, I hear everything works there.
Maturity is knowing you were an idiot, common sense is trying to not be an idiot, wisdom is knowing that you will still be an idiot.
|