[simpsonboy77]

We did 3 tests now. Our first was when both problem jaguars stopped responding to commands while in teleop enabled. Both jaguars stopped, IDs = 5 and 7. Our test was as follows:
Continue commanding an output to the motor with a joystick. The motor did not move.
We hit the user reset button on both.
Jaguar 7 started spinning again, 5 was motionless.
We reset 5 again, and 5 remained motionless after.
We power cycled and the problem was resolved.

Our second test occurred when jaguar 7 was commanding an output and we noticed the JaguarCANDriver crashed. When we commanded it to stop, the motor continued to spin.

We then unplugged ALL the CAN cables going into the problem jaguar. The status light began its slow yellow blink, but continued to spin the motor.

Our final test was when jaguar 7 entered a runaway. I then tried to press the user reset button, but there was no effect. It did not even blink as though it responded to the user reset. We looked on the 2CAN web interface and it reported no CAN bus errors, and the jaguar was reporting 0% throttle.

The motor almost sounds like it is being pulsed prior to it entering a problem state.

We are using kPercentVoltage, although we get errors in kVoltage and kSpeed mode.