Aloha from Oahu!
Quote:
|
Done but... 122 lbs. So, not done. But almost done. But, lots more programming to finish. But, ready for drive tests... almost.
|
And I feel your pain. We used Pro E for mass analysis using the density of 6061, only the density it had was wrong.... So instead of a 110 lb robot we ended up with one that was around 128. After making the hole saw set our best friend and finding fastening alternatives we got it down to 121.4 today. Almost there!
All in all, we have pretty much finished the robot and will begin practicing and debugging. Good luck!