Thread: Programming Pneumatics
View Single Post
  #3   Spotlight this post!  
Unread 17-02-2012, 15:21
chall3613 chall3613 is offline
Registered User
AKA: Candace
FRC #3613 (Team Wolf Pack)
Team Role: Programmer
  
Join Date: Jan 2012
Rookie Year: 2011
Location: New York
Posts: 28
chall3613 is an unknown quantity at this point
Re: Programming Pneumatics
I can't understand any of it. I don't know any "labview lingo".

All I need if for the compressor to stop at 120PSI and turn back on when it gets low. And i need the cylinder to go up when the trigger is held and go back down when it is released.

This year, no one comes. I have been working on programming since I'm the only one who even remotely understands anything, and I'm doing electrical. Which I have no idea about. I think I have everything I need because thats what the FRC examples show. And when I turn the robot on, after a minute, the compressor turns on, but doesn't stop.

I saw some other examples, but I don't know where thoes blue DIO and AI boxes are in the vis.
Reply With Quote