Thread: Problems with LabView Default Code
View Single Post
  #3   Spotlight this post!  
Unread 20-02-2012, 20:14
StealthMentor StealthMentor is offline
Registered User
FRC #1802
  
Join Date: Jan 2011
Location: USA
Posts: 16
StealthMentor is an unknown quantity at this point
Re: Problems with LabView Default Code
Actually, this sounds a lot like the incorrectly made ribbon cable problem We had a similar problem until we "fixed" our KOP ribon cable. PWM 1 was responding to the signal sent to PWM 3.
Reply With Quote