Quote:
Originally Posted by Fe_Will
Looking closer at the left edge of the board it appears that the resin has melted. We occurred similar issues last year and damaged 3 DSCs before locating the issue. By having the power and signal wires reversed on our pressure sensor we were sending 5V "the wrong way". In one instance the voltage was enough to desolder some of the contacts on the board. If the resin looks wavy and non uniform you have a definite wiring problem.
|
I don't recall seeing any resin damage (what you're seeing may be just the poor quality of photo resizing done by mspaint), but I didn't take that close a look at the board - making sure the robot got rewired correctly was the more pressing issue at the time
I'll make sure to take another look at it tomorrow.
But three sidecars...
Thanks for your input
