Quote:
Originally Posted by TEAMROCK2000
Has anyone had problems with any banbots 550 motors blowing up when u lower the speed in the programming.
|
Blowing up, as in exploding? I hope everybody was wearing safety glasses.
Seriously, if you want useful answers, you need to post useful information, such as:
- what is the motor driving?
- what is the gear ratio from the motor to the driven device?
- if the driven device is an arm of some sort, do you have an estimate of the torque load on it ?
- what was the %PWM command when this happened? how fast was the driven device moving (turning) when the motor "blew up"?
- Jag or Vic ?
- are the 550's air vents properly vented?
- anything else pertinent that you can think of