Quote:
Originally Posted by squirrel
If you put the corner noodle on the side bumper instead of the short front bumper, then you could make the front bumper only about 8" wide. But why would you do that, if you need to make the number fit the short front bumper?
We used longer noodles on our short front bumpers, so they would be the thing that filled in the corner. No problem fitting our 4 digit number on there. But we didn't get the stroke width right....it's almost 3/4". I think they'll pass?
The rules are kind of complex, and they do kind of dictate how you can design parts of the robot. Of course it turns out that if we'd have played with the balls more at the beginning of build season, we probably would not have split the front bumper, we would have just made our intake under the bumper, as wide as possible....since it's so easy to drive over the balls.
|
IMO, your numbers are very readable from a distance, and the stroke width isn't so much smaller that it's noticeable. have a plan if you need to, but i'm going to guess no one will notice, unless the inspector actually measures the numbers!