Quote:
Originally Posted by Daniel_LaFleur
1> when your manipulator flips out it looks like it breaks the front plane of the bot in more than 1 location. Are you concerned that it might be ruled 2 appendeges?
|
The entire thing is articulated as a single assembly. It is difficult to see from the photo, but there is a reinforcement bar all the way across the width of the bot right at the point where we cross the frame perimeter (on top of the bumper). We momentarily break the plane in two separate places during the act of deployment, but that has been explicitly allowed via Q&A and Team Updates.
As for numbers: from a full frontal view, you can actually read them just fine when your intake is deployed. The intake is mostly air
