|
Re: Trouble with deploying program
Are you doing "Run as startup" (NOT "Deploy") when you tried to download your code. That can prevent it from taking.
The PC you're using: - IP address matches the cRIO (e.g., team number)
- All other network interfaces Disabled
- All firewalls off
- All anti-virius programs off
- Ethernet connected to a switch (DLink preferred), connected to the cRIO?
You can try putting the cRIO in Safe Mode and reimaging with the cRIO Imaging Tool (a special sequence will occur), then turn Safe Mode off, reset the cRIO and try imaging again. All followed by putting your code on the cRIO using "Run as startup".
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 27-02-2012 at 11:39.
|