Quote:
|
It appears that the signal pin on the Jaguar likes to be grounded (correct me if I'm wrong?).
|
Pin2 on the Jag coast/brake "likes" to be
switched: Lo
(-0.3 to +1.3) is brake, Hi
(+2 to +5) is coast.
The GPIO
signal pin goes to Pin2 on the Jag coast/brake, to switch it from Lo to Hi.
The ground pin at the GPIO goes to Pin3 (ground) on the Jag coast/brake.
That would be my guess. Is that the way
your team does it, Al?