[mbone206]

Hi Alan

They are using some newer lap tops, windows 7... Initially had hard time for Windows 7 recognizing the Robot wireless, after many changes, finally recognized it. It initially did come up wit IP conflict when put wireless IP in with team id... I thought is was because when run driver station, it automatically sets LAN to team/computer IP, that is what I thought conflict was... I am not use to Windows 7 or very experience with computer networks, can you point me to any help, papers that would help see if there are other conflicting addresses as you suggest?

I believe they did at one point try tether, but will have them try again

BTW: Do you add caps on your motor terminals? What value/voltage rating suggest? Do you add caps on supply lines?


thanx for your support
Mark