View Single Post
  #33   Spotlight this post!  
Unread 14-03-2012, 23:17
Ether's Avatar
Ether Ether is offline
systems engineer (retired)
no team
 
Join Date: Nov 2009
Rookie Year: 1969
Location: US
Posts: 8,134
Ether has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond reputeEther has a reputation beyond repute
Re: Cim-Sim gearbox for shooter questions

Quote:
Originally Posted by RRLedford View Post
The gear overlap was still >80% since we pressed the pinion on less far down the shaft to anticipate this.
The cantilevered pinion would contribute somewhat to the stresses on the motor bearing.

Did you consider milling cooling grooves in the CIM-U-LATOR instead of using spacers?

http://www.chiefdelphi.com/forums/sh....php?p=1120101



Last edited by Ether : 14-03-2012 at 23:21. Reason: added link
Reply With Quote