Thread: Change to Initializing Inputs and Outputs
View Single Post
  #1   Spotlight this post!  
Unread 07-01-2003, 01:42
Jferrante Jferrante is offline
Registered User
#0506
  
Join Date: Aug 2002
Location: New York
Posts: 67
Jferrante is an unknown quantity at this point
Send a message via AIM to Jferrante Send a message via Yahoo to Jferrante
Question Change to Initializing Inputs and Outputs
In the section Initialize Inputs & Outputs I have noticed that all the pwm's which are normally set to start at 127 are totally missing for this years default code. Did anyone else notice this? Was the starting value necessary or was that just extra stuff that really wasnt needed?