Thread: Programming Pneumatics in Labview
View Single Post
  #1   Spotlight this post!  
Unread 20-03-2012, 16:53
geomapguy's Avatar
geomapguy geomapguy is offline
Centenary '18
AKA: Graham Maxwell
FRC #1818
Team Role: Mentor
  
Join Date: Jan 2012
Rookie Year: 2011
Location: Alexandria, LA
Posts: 535
geomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud ofgeomapguy has much to be proud of
Programming Pneumatics in Labview
Hello,

Here is our problem:
We have a pneumatic system setup with 1 compressor, 1 pressure switch, and 1 double solenoid.

How would I go about programming so that the compressor will turn on at the cRIO boot and the solenoid would activate when I press a joystick button.

Also... the compressor is connected through a spike into relay 1 on solenoid breakout and the double solenoid is connected to relay 2 and 3 on the solenoid breakout. The pressure switch is connected to digital output 1 on the digital sidecar
__________________
The Cowboys - FIRST Robotics Team #1818 2015-
The Bolton Bear Bots - FIRST Robotics Team #3666 2011-204 (30-26-0)
2014 Oklahoma Regional - 20/62 (6-4-0), 5/62 in OPR
2014 Arkansas Regional - 14/39 (8-7-0, Quarterfinalists with 1706 and 1939), 24/39 in OPR
2013 Lone Star Regional Dean's List Finalist!
2013 Lone Star Regional - 22/57 (6-5-0), 17/57 in OPR
2012 Bayou Regional - 16/49 (6-5-0)
2011 Dallas Regional - 10/52 (4-2-5, #6 Alliance Captain, Quarterfinalists with 2948 and 3350)
Reply With Quote