Quote:
Originally Posted by Joey Milia
Could you provide a pic of the internals, it's hard to say much just seeing the plates.
Consider how you are mounting the gearbox. Having that angle on the bottom won't help and I don't see any mounting holes already.
It doesn't seem to be a shifting transmission in which case it can be a lot thiner.
You should also reconsider your uses of a 17 tooth gear, I don't know where you plan to get it but something like 16 teeth is much more common.
Tristan has a good point, what benefit does this have over an andymark product? If your goal is to make something smaller/lighter than you could start with toughbox gearing and go from there.
|
The Bolts will be longer and the nuts just get put on the other side of chassis (sheet metal chassis)
Could be a lot thinner, but its my first transmission so i don't have any experience trying to compact it.
this is a 17 Tooth gear from Andy Mark.
Its just for Fun. I dont plan on making it better than AndyMark.
EDIT: Pic of Internals is now in Original post