View Single Post
  #32   Spotlight this post!  
Unread 09-04-2012, 11:08
Kevin Sevcik's Avatar
Kevin Sevcik Kevin Sevcik is offline
(Insert witty comment here)
FRC #0057 (The Leopards)
Team Role: Mentor
 
Join Date: Jun 2001
Rookie Year: 1998
Location: Houston, Texas
Posts: 3,760
Kevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond repute
Send a message via AIM to Kevin Sevcik Send a message via Yahoo to Kevin Sevcik
Re: Tube Versus Channel

Quote:
Originally Posted by Siri View Post
Is the circular saw blade really that much faster than a horizontal? That's impressive. I may make the investment.
It IS that much faster cutting aluminum extrusions. I'd used it on solid aluminum, and it's probably about equal on the cutting speed. But even then, you're saving time on post-processing. The circular saw leaves a cut that's much flatter and smoother, with deburring only necessary to remove the occasional thin burr and round off those sharp cut edges. Even past the processing speed, though, is the fact that it's a compound miter saw. If you maintain it and keep your fences square and in-line, you can pretty accurately cut whatever angle you want.

It's also a lot easier to get cuts to the exact length you want on this saw. Cut your part 1/16" longer and measure it. If it's right, stop. Otherwise, with the saw blade down and off, slide the piece over till it touches the flank of the blade. Hold your part, pull the blade up, turn it on and run it down and you've just taken off the tiny distance between the the flank of the saw blade and the outside of the kerf. It's something like 1/32" or less, so with a little extra effort, your nice square cut tube will be within 1/32" of where you want it.

The only downside is that a standard woodworking miter saw will only be good for cutting aluminum and your kerf is definitely larger than on a bandsaw. But it's still only 0.094", so unless you're cutting a heck of a lot of 0.5" pieces or something, you're not going to notice or care.
__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.

Lone Star Regional Troubleshooter