|
Re: TI and future Jaguars
Since there is little in the way of actual schematics in this topic I should point out again.
If you take the Jaguar and look at the schematic. Look at the sections of it that handle the power. Look at the sections of it that handle the control.
Take the sections that handle the power and make them the power module.
Take the sections that handle the control and make that the interface module.
Stack them on top of each other.
You've just made the same modular electronic motor control I've been discussing and it's functionally (from the software perspective) the same.
What you just envisioned also has a smaller footprint.
So, I'm not following how redesigning the Jaguar...is all that much different from redesigning the Jaguar in a modular design. I realize it might be slightly more expensive. However, as I stated the original integrated result didn't exactly work as the designers intended on the sales end.
We bite nearly the same bullet. It's just that when we finish we can take the Stellaris off and use other things.
Some minor tweaks here and there but for the most part most of these circuits are not all that different from one another.
Last edited by techhelpbb : 04-05-2012 at 13:57.
|