[Sarakiro]

if you post a picture I can validate this, however I believe I know what you are talking about. If I recall correctly (if you have a gearbox) you can cut a piece of aluminum c channel down to two inches (maybe 2.5) find a center line after cutting off one side of the c channel and from the center line, go about .5 inches out, and mark two lines (one from both side) I believe the firth hole should be some weird 7/16 away from the now only remaining wall of the c channel, and the second, (again, assuming a gearbox [we used a 4:1]) can be measured. holes shopuld be marked half an inch from the center and drilled using .25in drill bit. (I made about 8 of these in the during the build season)

good luck-

If you post a picture, I can validate this.

RS