View Single Post
  #6   Spotlight this post!  
Unread 29-05-2012, 13:06
daniel_dsouza daniel_dsouza is offline
does what needs to be done.
FRC #2449 (Out of Orbit Robotics)
Team Role: Alumni
 
Join Date: May 2011
Rookie Year: 2011
Location: Chandler, AZ
Posts: 231
daniel_dsouza has a spectacular aura aboutdaniel_dsouza has a spectacular aura about
Re: pic: The humble wrench

Quote:
Originally Posted by Richard View Post
Is your model parametric, so that you can drive dimensions for a wrench of any size from a table? Since this is a learning exercise, making the model parametric would be a good goal.
Can you recommend how I would go about doing this? I didn't even know this was possible! I had just stuck with a size 22, because taking measurements was easy.
Reply With Quote