Thread: EE question: convert RS232 voltages to RC servo
View Single Post
  Spotlight this post!  
Unread 19-06-2012, 08:47
Hugh Meyer's Avatar
Hugh Meyer Hugh Meyer is offline
Registered User
FRC #1741 (Red Alert Robotics)
Team Role: Mentor
  
Join Date: Feb 2009
Rookie Year: 2008
Location: Greenwood Indiana
Posts: 158
Hugh Meyer has much to be proud ofHugh Meyer has much to be proud ofHugh Meyer has much to be proud ofHugh Meyer has much to be proud ofHugh Meyer has much to be proud ofHugh Meyer has much to be proud ofHugh Meyer has much to be proud ofHugh Meyer has much to be proud of
Re: EE question: convert RS232 voltages to RC servo
Ether,

As Eric said the input is an opto isolator. If you look at the schematic for the Jaguar, it is very similar, but not identical. A few years ago I made a device that would drive the victors and found it required about twice as much current as the Jaguars. I wanted the same device to drive either.

On your drawing you didn't say if the other side of the input was going to + vcc or gnd. If it is going to gnd, then 1200 will not supply enough current.

I will try to dig up the stuff I used. Seems like I remember it needed to be in the 400 ohm range.

-Hugh