|
Re: IRI - Looking to borrow a piston
If the problem is near the end of the shaft and you don't need the full 24" stroke you could use spacers on the shaft so it does not retract all the way into the cylinder and doesn't get into the bad part of the shaft.
You could also not hook up the retract end and cap the solenoid and use surgical tubing to retract the cylinder instead of air.
__________________
"Champions are champions not because they do anything extraordinary but because they do the ordinary things better than anyone else." —Chuck Knoll
2015 Indianapolis District Winner
2014 Boilermaker Regional Industrial Design Award
2013 Smoky Mountain Regional Industrial Design Award
2012 Boilermaker Engineering Excellence Award
2010 Boilermaker Rockwell Innovation in Control Award.
2009 Buckeye J&J Gracious Professionalism Award
2009 Boilermaker J&J Gracious Professionalism Award
2008 Boilermaker J&J Gracious Professionalism Award
2007 St Louis Regional Winners
|