WELCOME TO CHIEF DELPHI!
First off, if you want to learn Autodesk Inventor, there are some very good tutorials all in
this thread.
I personally learned a whole lot from the
Built By Design tutorials, a set of Autodesk Inventor tutorials specifically for FRC purposes.
As for libraries, I think Aaron has you pretty well covered.
Good luck!
Feel free to PM me with any questions!
__________________
(Hanging out with my buddies at
610)
Robotics, it's not just a club, it's a career.
FLL Referee (2012-Present)
2014 Gateway Robotics Challenge winners (With 2481 and
1985)
2011 St. Louis Regional Winners (With 1985 and 3284)
2010 Highest Rookie Seed
I am the guy in the golden hat, say "Hi!" to me at WORLD CHAMPIONSHIPS!!!