Thread: pic: Delrin Poly Cord Pulleys
View Single Post
  #13   Spotlight this post!  
Unread 28-08-2012, 12:01
Mk.32's Avatar
Mk.32 Mk.32 is offline
Registered User
AKA: Mark
FRC #2485 (W.A.R. Lords)
Team Role: Engineer
  
Join Date: Jan 2011
Rookie Year: 2011
Location: San Diego
Posts: 770
Mk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud of
Re: pic: Delrin Poly Cord Pulleys
The ID of the pulleys are .64 in.
We are using a smaller diameter then what was recommend but from past experience not have a lot of problems with it.

We are going to put these in later today, and I will report back about any problems.
__________________
Engineering mentor: Team 2485: WARLords 2013-

Team President: Team 3647 2010-2013
Reply With Quote