Splitting off of this thread here;
http://www.chiefdelphi.com/forums/sh...hreadid=107998
I'm curious to know the following (please, complete data sets so it's useful) from teams who have run timing belt in drive
-Was it 1:1?
-Toothcount on pulley
-Profile and Pitch
-Belt Width
-Wheel Diameter and Type (roughtop, colson, etc...)
-Gear ratio before the pulley (high and low gear)
-tensioners?
-If exact c-c, did you add/subtract from this number? Also, what type of machine was the part fabricated on.
Once some information is posted, I'll tabulate it for comparison.
973 is prototyping belts for a wcd this fall (after exclusively using belts over chain in the 2012 season), and will update with our results.
IF you could post directly in this google doc that'd be great!
https://docs.google.com/spreadsheet/...2J4M 2c#gid=0